A s s e m b l y S t e p 3
Assembly Instructions
A s s e m b l y S t e p 3
Align and attach the
Pedal Connection Joint (#14)
on the
Left Pedal Tube
(#03)
to the left
Crank (#16)
. Insert a
Bolt (#19)
through a
Special Washer (#20)
followed by
Pedal Connection Joint (#14)
and
Crank (#16)
. Screw the
Bolt
(#19)
tightly into the
Crank (#16)
by turning CLOCKWISE and then secure it with
the
Nylon Nut (#18)
by turning it COUNTERCLOCKWISE. Align and attach the
Left Coupler Bar (#05)
to the
Left Pedal Tube (#03)
. Secure them together using
a
Bolt (#29), Washer (#42)
and
Nylon Nut (#39)
. Attach the
Left Pedal (#47)
to
the
Left Pedal Tube (#03)
and secure them together using three
Hex Bolts (#32),
three
Washers (#44)
and three
Nylon Nuts (#41)
. Repeat this process on the
other side with the
Right Pedal Tube (#04)
and
Right Coupler Bar (#06)
.
Hardware Required
#19. Bolt (1/2”x97 mm
)
[2 Pieces]
#29. Bolt (M10x58 mm)
[2 Pieces]
#32. Hex Bolt (M8x40 mm)
[6 Pieces]
#33. Bolt (M8x20 mm)
[2 Pieces]
Washer
#42. Washer (M10
)
[2 Pieces]
#25. D Shape Washer (19 mm)
[2 Pieces]
#24. Special Washer (19
mm) [2 Pieces]
#20. Special Washer (16
mm) [2 Pieces]
#44. Washer (M8
)
[8 Pieces]
Nut
#18. Nylon Nut (1/2”)
[2 Pieces]
#39. Nylon Nut (M10)
[2 Pieces]
#41. Nylon Nut (M8)
[6 Pieces]
Others
#26. Round Cap
[2 Pieces]
Bolt
Please refer to the diagram below and pay special attention to corresponding left & right side parts.
Misplacing parts during assembly will lead to incorrect assembly and may result in serious injury.
Slide the
Couple Bar Axle (#15)
through the center slot below the
Tension
Controller (#27)
knob on the
Center Post (#02)
and center it so it is evenly
distributed on the left/right sides. Next, slide one
Special Washer (#24)
on each side
then, followed by corresponding
Left/Right Coupler Bar (#05/#06)
. Secure each
side with a
D Shape Washer (#25)
,
Round Cap (#26)
,
Washer (#44)
, and a
Bolt (#33)
.
Page 8
BRM 2788/3588
