Page 11
A s s e m b l y S t e p 6
Remove the three
Washers (#44)
and three
Nylon Nuts
(#41)
that are pre-assembled on the back of the
Seat (#63)
and set them aside as they will be used later in this step.
Attach the
Seat (#63)
onto the
Horizontal Seat Bar (#11)
and make sure that the
Seat (#63)
is pointing directly toward
the short end of it and then tighten with three
Washers (#44)
and three
Nylon Nuts (#41)
that were previously removed.
The
Knob Bolt (#65)
can be loosened to adjust the distance
of the seat from the handle bars. Make sure to tighten the
knob after making any adjustment.
Insert the
Seat Post (#10)
into the mouth of the post that is
protruding from the
Main Frame (#01)
down a minimum of 4
on the
Seat Post (#10)
are facing the
front
before inserting.
Secure the
Seat Post (#10)
(now with
Seat (#63)
attached)
using the (previously removed)
Knob Bolt (#65).
Hardware Required
Washer
#44. Washer (M8
)
[3 Pieces]
Nut
#41. Nylon Nut (M8)
[3 Pieces]
W A R N I N G
Do not remove the
Seat (#63)
for any
reason after you have installed it.
Exercising on this unit without the
Seat
(#63)
can result in SERIOUS INJURY.
Ensure the seat is locked in place by
tightening the two knobs prior to use.
Assembly Instructions
If pre-assembled, remove the
Knob Bolt (#65)
on the mouth of
the
Main Frame (#01).
The assembly process is now complete.
However
, for your own safety,
please make sure to read this entire Owner’s Manual which includes
safety instructions and warnings, as well as any safety/warning labels
affixed to the product before use.
For your safety, please visually and functionally inspect and test the unit
after assembly is complete.
inches to engage the lowest hole. Make sure the holes
BRM 2788/3588
