A s s e m b l y S t e p 2
Remove the
Bolts (#34), Spring Washers (#45)
, and
Arc
Washers (#43)
that are pre-assembled on the
Main Frame
(#01)
and set them aside as they will be used later in this
step.
Connect the
Monitor Wire (Upper) (#61)
to the
Monitor
Wire (Lower) (#62)
and then follow the instructions in the
diagram below to connect the
Tension Wire (#28)
. After
connecting the
Tension Wire (#28)
to the
Tension
Controller (#27)
slide the
Center Post (#02)
onto the
Main
Frame (#01)
and secure it using the
Bolts (#34), Spring
Washers (#45)
, and
Arc Washers (#43)
that were previously
removed.
Hardware Required
#34. Bolt (M8x15 mm)
[6 Pieces]
Washer
#43. Arc Washer (M8)
[6 Pieces]
#45. Spring Washer (M8)
[6 Pieces]
Bolt
assembling the
Make sure this wire is exposed and accesible
before
Center post (#02).
Insert the tip of the
Tension
controller (#27)
wire into the
Tension
wire (#28)
head at an angle. Tilt the
Tension controller (#27)
wire into the
crevice and then pull upward.
TENSION WIRE ASSEMBLY
Tension Adjustment
To increase the tension (+ higher level of intensity), turn the
Tension Controller (#27)
in a clockwise direction.
To decrease the tension (- lower level of intensity), turn the
Tension Controller (#27
) in a counter-clockwise direction.
"1" is the lowest level of tension (easiest level for workout);
"8" is the highest level of tension (most difficult level for workout).
55
40
1
2 3
4
55
40
1 2 3
4
STEP3:
Assembly Instructions
BRM 2788/3588
Page 7
