A s s e m b l y S t e p 5
Remove the
Screws (#37)
that are pre-assembled on
back of the
Monitor (#17)
and set them them aside as
they will be used shortly in this step. Connect the
Wire (Upper) (#61)
to the
Monitor (#17)
and connect the
Pulse Sensor Wire (#60)
to the
Monitor (#17)
. Secure
the
Monitor (#17)
to the bracket of the
Center Post (#02)
using four
Screws (#37)
that were previously removed.
Hardware Required
#37. Screw (M5x12 mm)
[4 Pieces]
Screws
Assembly Instructions
After complete assembly: If the computer
is
not picking up your hand pulse signal
(or you are getting inaccurate readings),
Please refer to our “Troubleshooting”
section on
Page 15
for other troubleshoot
issues.
HAND PULSE SIGNAL
Troubleshooting
BRM 2788/3588
Page 10
