Boca Systems Complete IDE Series, Руководство пользователя

Страница: 6 / 40

6
Complete IDE Series: IDE200
QuickStart
• Review package contents
• The ID200 controller
• 34-pin diskette drive cable
• 40-pin hard drive cable
• Configure the jumpers or accept the default settings (see diagram on
next page).
• Insert the IDE200 controller in any available 16-bit expansion slot.
• Connect one end of the 34-pin floppy cable to your floppy drive and
the other end to the J2 connector on the IDE200. Make sure the
colored stripe (often red) goes to Pin 1.
• Connect one end of the 40-pin hard drive cable to your hard disk
drive and the other end to the J1 connector on the IDE200. Make sure
the colored stripe (often red) goes to Pin 1.
• Attach your serial device to J4 (serial port A) and your parallel
printer to J9. Secure the serial connector and bracket assembly to a
vacant rear slot. Attach the free end of the cable to J3 (serial port B) on
the IDE200. Then attach your serial device to the external connector
on the bracket assembly.
• Power up your system using a DOS diskette.
• If you connected the IDE200 to a new hard drive, run FDISK and
FORMAT to prepare your IDE hard drive for use; otherwise, simply
power up your system and the IDE200 will automatically recognize
your existing drive.