BMZ Hyperion 15, Оригинальная инструкция по установке

Страница: 13 / 28

3 Commissioning
V1.2 | 06/08/2020 Page 13 of 28
2.4 Status and SOC display
During operation 6 LED fields indicate status and SOC of the battery system.
LED 10 seconds

Status
Green – on Discharge mode
Green - flashes
(0,5 s on / 1 s off) Ready (battery relay engaged - waiting for
charge or discharge)
Green – flahes slowly
(1 s on / 5 s off)
Standby (battery system relay open)
Blue - on Charging mode
Blue - flashes
(0,5 s on / 1 s off) Diagnosis or shutdown of the battery system
Blue - flahes slowly
(1 s on / 5 s off) System start, relay test or software update
Red - flashes quickly
(0,2 s on / 0,2 s off) System error - System has disconnected
battery from inverter
Red – flashes
(0,5 s on / 1 s off)
Error during start-up of the battery system -
battery remains disconnected
3 Commissioning
3.1 Safety Instructions
The installation may only be carried out by qualified electricians according to IEC
60204
-
1 (International Electrotechnical Commission).
The housing including electronics weighs 43 kg. One modular battery weighs 22 kg.
Heavy lifting can cause a disturbance of the musculoskeletal system.

Lift the Hyperion cover (11 kg) and base (32 kg) separately.

If necessary, do not lift the Hyperion base alone or be sure to use
transport aids.
Risk of crushing and abrasions when lifting and inserting the modular batteries.

Use foot and hand protection.
3.2 Installation
3.2.1 Transport
If the installation site is difficult to access, it is recommended that the base and the
hood of the system housing be carried to the installation site separately:
1. Open the packaging of the Hyperion system housing.
2. Unscrew 2 screws (4 mm Allen key) at the front of the bottom of the
system housing.
3. Remove the hood from the system housing base.
4. Carry the hood and base to the installation site individually.
Table 4: Overview LED
status codes
Guidelines
Handling, transport
Installation site
difficult to access