BMI IDP1010, Руководство пользователя

Страница: 7 / 29

6
Installation and Operation
SAW STAND SETUP
1. Remove the folding stand from its box.
2. While holding the stand upright, spread both sets of legs
apart and swing the workbench over and on top of the
legs.
3. Seat the saw securely onto the stand. (see figure 2)
BLADE INSTALLATION
1. Loosen blade guard adjustment knob located at the rear
of the blade guard. Raise the blade guard to the highest
position and retighten the knob.
2. Remove the blade shaft nut and outer flange. (see fig-
ure 3) If a blade has been mounted, hold the blade with
one hand and use the other hand to loosen the nut with
the universal wrench. Remove existing blade.
3. Mount new blade, but make certain the arrow on the
blade coincides with the rotation direction of the shaft.
4. Attach outer flange and blade shaft nut. Hold the blade
with one hand and use the other hand to tighten the nut
with the universal wrench. Make certain the flanges are
pressed flush against the blade and that the nut is firmly
tightened, but do not over tighten.
5. Loosen blade guard adjustment knob, lower the blade
guard and retighten the knob.
WATER PUMP INSTALLATION
1. Remove the water pump from the box and check that it
is not damaged.
2. Slide the pump onto the U-shaped bracket located at
the bottom of the frame. The pump should be oriented
such that the water outlet is horizontal. (see figure 4)
3. Connect water hose from the bearing housing located
on the underside of the cutting head to the water pump.
Plug the pump’s power cord into the connector leading
from the switch box.
4. Fill the water tray so that the water intake is fully im-
mersed. Proper water level must be maintained at all
times during saw operation.
Disconnect the pump before attempting to handle the
pump. Never operate pump without water in the tray.
WARNING:
figure 3
figure 2
figure 4