BMI IDP1010, Руководство пользователя

Страница: 14 / 29

IDP1010 • Owner’s Manual
13
3. If the table shifts to the right as it travels away from the
user, a shim needs to be added to the guide roller fur-
thest from the ruler guide. On the other hand, if the
table shifts to the left, a shim needs to be added to the
guide roller closest to the ruler guide. Remove the ap-
propriate guide roller to insert a shim between the roller
and table, then reattach. (see figure 14) Depending on
the severity of the shift, more than one shim may be
required.
4. After adding shim(s), mount the table onto the guide rails
by reversing the instructions in step 2. Move the rails
toward each other to engage the horizontal rollers to the
right guide rail as shown in figure 10. Realign the table
to the blade using method 1. Check to see if any shifting
persists. A shift tolerance of 0.2mm is allowed. A shift
in excess of that will require further adjustment—repeat
step 3.
5. Once alignment is successful, replace saw back into the
water tray.
Method 2:
This procedure corrects another source of misalignment
that occurs when the table’s orientation is not parallel with
the guide rails.
1. Lift the saw up from within the water tray and place it on
a flat level surface. Use the universal wrench to loosen
(but not remove) the fasteners from either end of both
guide rails. Move each rail away from the other, so that
the horizontal rollers are clear of the right guide rail. (see
figure 11)
2. Remove rubber cap A on the left side of the table. Loos-
en the exposed lock nut using a 13mm socket wrench.
Use a flat screwdriver to turn the shaft of the roller clock-
wise to lower it by approximately 3/8”. (see figure 12)
Evenly lift up the table to disengage the guide rollers
from the left guide rail. Once the guide rollers are clear,
shift the table to the right to clear the left horizontal roller
of the rail. Remove the table from the guide rails. (see
figure 13)
Horizontal
Roller
Flat Roller
figure 14
Shim
Guide Roller
Rubber Cap B
Flat Screw Driver
Size 13mm
Socket
Wrench
figure 12
Rubber Cap A
Rubber Cap C
figure 11
Loosen Fasteners
Right Guide Rail
Clearance
Horizontal Roller
Guide Roller
Horizontal Roller
figure 13
1
2
Left Guide Rail