BMGi EGA-04, Инструкция по установке и эксплуатации

Страница: 4 / 12

IMPORTANT - Single swing AUTO TRAVEL procedure:
ENSURE THE GATE WAY ENTRANCE IS
CLEAR OR ANY OBSTRUCTIONS.
To perform the ‘AUTO TRAVEL’ function, you will need to activate your gate
opener with a remote. Press Remote Button (or the remote you are using for
this system) for 2 seconds or until the small LED light on the remote flickers,
now release your remote button. You should observe “OP”
appearing on the Digital Display “MENU”.
For a Single swing gate , the display “MENU” will show OP to say the control
board has put Motor 2 gate into an OPEN position, the “MENU” will then show
SP to say the control board has turned Motor 2 off.
With the control board now knowing your gate is in the open position, you will
need to press the DEC and INC buttons at the same time for 5 seconds or
until one gate starts to close, now release INC and DEC buttons (you must
press and hold in both buttons at the same time for this to work, pressing the
buttons individually first will not allow the control board to run its
‘AUTO TRAVEL’ function).
The gate Motor 2 will now close with the display “MENU” displaying CL
(Close), after Motor 2 has closed the gate, the “MENU” will display SP (Stop).
1 second after Motor 2 has closed the gate it will activate again with the
“MENU displaying OP (Open), after Motor 2 has opened the gate, the “MENU”
will display SP (Stop). Wait 10 seconds before operating the gate opener.
Travel function now completed.
Press remote trigger button on your remote for 2 seconds or until the LED light
starts to flicker, then release the button.
Check that your gate operates correctly. Check if your force settings need to
be adjusted.
If they require adjusting, please refer to the MENU settings to adjust P3, P4
and P6.
Majority of gates won’t require any adjustments.
Auto Travel Function
SCAN ME