BMGi EGA-04, Инструкция по установке и эксплуатации

Страница: 3 / 12

IMPORTANT - Dual swing AUTO TRAVEL procedure:
ENSURE THE GATE WAY ENTRANCE IS
CLEAR OR ANY OBSTRUCTIONS.
To perform the ‘AUTO TRAVEL’ function, you will need to activate your gate
opener with a remote. Press Remote Button (or the remote you are using for
this system) for 2 seconds or until the small LED light on the remote flickers,
now release your remote button. You should observe “OP”
appearing on the Digital Display “MENU”.
For a dual swing gate , the display “MENU” will show OP to say the control
board has put Motor 1 gate into an OPEN position, the “MENU” will then show
SP to say the control board has turned Motor 1 off. The display “MENU” will
repeat this sequence for Motor 2.
With the control board now knowing your gates are in the open position, you
will need to press the DEC and INC buttons at the same time for 5 seconds
or until one gate starts to close, now release INC and DEC buttons (you must
press and hold in both buttons at the same time for this to work, pressing the
buttons individually first will not allow the control board to run its ‘AUTO TRAV-
EL’
function).
The gate connected to Motor 1 will close first, the “MENU” will display CL
(Close), after Motor 1 has closed the gate, the “MENU” will
display SP (Stop). Motor 2 will now close with the “MENU” displaying CL
(Close), after Motor 2 has closed the gate, the “MENU” will display SP (Stop).
1 second after Motor 2 has closed the gate it will activate again with the
“MENU displaying OP (Open), after Motor 2 has opened the gate, the “MENU”
will display SP (Stop). Motor 1 will now open the gate with the “MENU” dis-
playing OP (Open), once the gate is open the “MENU” will display SP (Stop).
Wait 10 seconds before operating the gate opener. Travel function completed.
Press the remote trigger button on your remote for 2 seconds or until the LED
light starts to flicker and then release the button.
Check that your gates operate correctly. Check if your force settings need to
be adjusted. If they require adjusting, please refer to the MENU settings to
adjust P1 through to P4 as well as P5 and P6.
Auto Travel Function
SCAN ME