G2S BPAP Series User Manual V2.1
19 / 43
12. Routine Use
12.1 Connecting the Tube
Connect the power cord, power adapter, and tube properly according to the instructions in
the First Time Setup (Chapter 11). Connect the mask and headgear according to the user
manual for the mask.
CAUTION!
• Before each use, examine the tube for any damage or debris. If necessary, clean the tube
to remove the debris. Replace any damaged tube. Make sure that the mask does not leak.
12.2 Adjusting the Tube
Lie down on your bed, and adjust the tube so it is free to move if you turn during sleep.
Adjust the mask and headgear until you have a comfortable fit and until there are no airflow
leaks around the mask.
12.3 Turning on the Airflow
Press
the Knob
to turn on the airflow. The screen will display treatment pressure and
other information.
12.4 Heating the Water
Pay attention to the humidifier indicator lights when using the humidifier. The indicator lights
indicate the On / Off state of the humidifier. It is off when all indicator lights go out.
CAUTION!
• Observe the water level of the water chamber before using the humidifier. Make sure there
is sufficient water in the water chamber, and avoid heating the humidifier with an empty
water chamber.
12.5 Using the Ramp Button
Every time
the Ramp Button
is pressed, the pressure will drop to the initial pressure,
and then gradually rise to the prescribed treatment pressure according to the preset ramp
time, so as to make the patient fall asleep easily. The screen displays a real-time countdown
of the remaining ramp time in minutes.
CAUTIONS!
• You can press
the Ramp Button
as often as you wish during sleep.
• The ramp feature is not prescribed for all users.
12.6 Turning the Device Off
Take off the mask and headgear, press and hold
the Knob
for two seconds, and the device
will stop delivering air. Disconnect the power cord from the power outlet to power off the device.
