28-6-2011 13 033000=13069F
3.2.1 Using the Comfort Remote Control
IMPORTANT:
When inserting the batteries, the switch should not be in setting 2!
1) Install batteries
Open the battery compartment on the back of the remote control and place the battery
(4x AAA, preferably use alkaline batteries). Observe polarity (+/-).
2) Initializing the SH600
For activating, press the Panic Key (1) until the control indicator comes on. Set the mode
switch to the SEC position.
3.2.2 Registering the Comfort Remote Control with the Base Console
1. To access the menu, press the menu UP or menu DOWN button. The display now shows
ENTER PIN
.
2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). The
display is cleared and shows a * for each number entered.
3. When the PIN code has been entered correctly, the word
INSTALL
will show up on the
display.
4. Press OK. The display now reads
INSTALL ZONE
.
5. Set the switch to SEC. Press the ARM HOME button on your Comfort Remote Control. The
console will beep to confirm. The display will read
RMOT 2 SET
.
If you have more than 2 remote controls installed, it will show e.g.
RMOT 3 SET, RMOT 4 SET, …
RMOT 16 SET
. You can register up to 16 remote controls.
6. Repeat step 5 for every remote control you wish to register.
7. Press CLEAR to go back to the first menu item. Press CLEAR again to quit the menu. To
confirm your choice, press 1 for Yes or 2 for No. If you choose Yes, you will quit the menu. If
you choose No, you go back to the first menu item.
4. Installing the sensors
4.1 Door/Window Sensor DS18
1.
Transmitter part
– Built-in antenna.
2.
Control indicator LED
– When pressing the Tamper contact button, or when the unit is
transmitting a signal to the base station, this LED will light up. When the LED blinks weakly,
batteries have to be replaced.
3.
Magnet contact
– The distance between magnet and contact may not be more than
5mm. When mounted, make sure the small arrows on the magnet and transmitter base part
are lined up.
4.
Screw holes
for mounting the sensor.
5.
Switch for entry delays
– For setting a delay time of approximately 30 seconds.
6.
Tamper contact
.
7.
Battery compartment
.
8.
Connection for extra wired contact
.
