28-6-2011 20 033000=13069F
+Switching on the ARM AWAY function
Via the console
Press the ARM AWAY button on the console. The system will be activated after a short delay
(delay can be set, see exit delay 8.1). During the delay you will hear a couple of tones at the
same pitch, and the display will read
EXIT DELAY
.
After switching the system to
ARMED AWAY
mode, the entry delay will be used for DS18
Door/Window Sensors (DS18 switch set to MAX) when you enter the house. This means you have
enough time to switch off the system via the console without triggering the alarm. The delay
times can be changed, see 8.1.
Also Motion Sensors registered to zone 15 and/or 16 will have an entrance delay according the
time set. This gives the opportunity to have entrances secured via Motion Sensors.
Besides the Security function, the
ARM AWAY
button on the console reflects Temperature
Setback options, to be used for energy saving:
Press the
ARM AWAY
button on the console. The system will be activated after a short delay:
-A
single
press: Thermostat remains setting of respective TS10. Display will show
COMFORT.
-Press
twice
; thermostat level will be set to Economy Level. Display will show
ECONOMY.
-
Third
press: thermostat level will be set to Frost Level. Display will show
FROST
.
The first press of ARM AWAY will leave the thermostat working exactly as it would do if the system
was not armed i.e. it will follow the set-point on the thermostat(s) unless there is a timer event set
which could change it.
Via the Key Chain Remote Control KR18
Press the ARM button. The alarm is switched on instantly.
Via the Comfort Remote Control SH600
Set the slide switch to SEC. Press the ARM AWAY button. The alarm is switched on instantly.
+Switching on the ARM HOME function
Via the console
Press the ARM HOME button on the console. The alarm is switched on instantly.
-A
single
press arms all Door/Window Sensors. Display will read
ARM HOME 1
.
-A
double
press of ARM HOME actives all Sensors in zones 1-16. Display will read
ARM HOME 2
.
Via the Key Chain Remote Control KR18
You cannot switch on the ARM HOME function with this remote control.
Via the Comfort Remote Control SH600
Set the slide switch to SEC. Press the ARM HOME button. The alarm is switched on instantly.
6.2 Panic alarm
The panic alarm can be switched on in case of an emergency, independent of whether the
security system is Armed or Disarmed.
The telephone message indicates the emergency sensor is triggered and that it is not the
burglar alarm. This is done by a default extra message to your own spoken telephone message.
This standard multi-lingual message is embedded into the system.
You can activate the panic alarm in two ways:
1. Activate the alarm via the KR18 Key Chain Remote Control
Keep the ARM and DISARM buttons of the remote control pressed simultaneously. The panic
alarm is instantly activated. Depending on the console settings the siren will or will not be
activated (see 9.1).
2. Activate the alarm via the SH600 Comfort Remote Control
