blupura BLUBAR, Руководство по эксплуатации и обслуживанию

Страница: 16 / 38

16
Functions of the volumetric keypad
The water cooler (I.T. model) is equipped with a VOLUMETRIC dispensing system.
The dispensing quantities are easily PROGRAMMABLE during installation.
On turning on the unit, the default settings are as follows: the upper buttons
dispense 200 ml of water (a cupful), whereas the lower buttons dispense 1000 ml
(1 litre).
BUTTON FUNCTIONS:
- SPARKLING WATER UPPER DISPENSER button (P.1)
- COLD WATER UPPER DISPENSER button (P.3)
- SPARKLING WATER LOWER DISPENSER button (P.2)
- COLD WATER LOWER DISPENSER button (P.4)
The pre-set quantity of water is dispensed, but you can stop the dispensing
process at any time by pressing the button again.
SETTING THE QUANTITIES:
Thanks to the Volumetric dispensing functionality, you can customize the pre-set
quantities dispensed by each of the 4 buttons. Normally, the upper buttons are
used for the dispensing of small quantities, with the lower buttons being used for
the dispensing of larger quantities.
To enter the programming mode, press and hold (for > 4 seconds) the following
combination of buttons: P.5 + P.3 + P.4 (Energy Saving the two cold
water buttons). When you enter the programming phase, you will hear three
consecutive beeps.
In this phase, Led L.1 + L.2 start to flash.
To set the maximum dispensing limit for a specific button, press the button
in question to start the dispensing process and press it again once you have
reached the desired quantity. Repeat the process for the remaining buttons.
To exit from the programming mode, press and hold (for > 4 seconds) the
following combination of buttons: P.5 + P.3 + P.4 (Energy Saving the two
cold water buttons), save the data and set the new limits.
The maximum settable quantity for each button is around 3,0 litres, which equates
to a 65-second dispensing session.
FUNCTIONALITY WITH ALARMS ACTIVATED:
“NO WATER” ALARM: This alarm is triggered when the pump sends the NO
WATER signal. In this case, the associated BLUE led L.1 starts to flash quickly and
the sparkling water dispensers do not work. The other dispensers continue to
work as normal. To reset the alarm, turn the unit off and back on again.