Blumfeldt 10035140, Руководство пользователя

Страница: 47 / 124

47
EN
Problem Cause / Condition Solution
Pilot won’t stay lit. Dirt build up around
pilot. Clean dirt from around
pilot.
Connection between
gas valve and pilot
assembly is loose. Tighten connection and
perform leak test.
Bad thermocouple Replace thermocouple.
Burner won’t light. Gas pressure is low. Replace gas cylinder.
Blockage in orifice Clear blockage
Control knob is not
in “LOW“ or “HIGH“
position. Turn control knob
to “LOW“ or “HIGH”
position.
Burner flame is low.
Note: Do not operate
heater below 5 °C
(40 °F).
Gas pressure is low. Replace gas cylinder.
Outdoor temperature
is higher than 5 °C
(40 °F) and tank is less
than 25 % full.
Replace gas cylinder
Supply hose is bent or
kinked . Straighten hose and
perform leak test on
hose.
The control knob is in
“HIGH“ position. Turn control knob to
“OFF“, let it cool to
room temperature
and check burner and
orifices for blockage
Emitter glows uneven.
Note: Bottom 2.5 cm of
emitter normally does
not glow.
Gas pressure is low. Replace gas cylinder.
Base is not on a level
surface. Place heater on a level
surface.
Heater is not level. Level heater.
Carbon build-up Dirt or film on reflector
and emitter.
Clean reflector and
emitter.
Thick black smoke Blockage in burner. Turn control knob to
“OFF“, let it cool to
room temperature,
remove blockage and
clean burner inside and
outside.