Hardware User Manual - Argos3D-P33X
Last change: 22 June 2017
Version 6
© BECOM BLUETECHNIX 2017
Page 15 | 26
No.
Signal
Type
Description
1
IN2A
I (0V to 50V)
Relay contact A
2
IN2B
I (0V to 50V)
Relay contact B
3
IN1A
I (0V to 50V)
Relay contact A
4
IN1B
I (0V to 50V)
Relay contact B
Table 4-2: General purpose input 1 & 2 connector description
An optocoupler SFH6286-2T from Vishay is used for each general purpose input.
OFF-Range: 0V to 2V.
ON-Range: 5V to 50V.
4.3.4
General purpose output 1 & 2 (d)
This 4 pole 3.5mm terminal connector allows plugging a cable entry plug like
691361100004
from Würth
Elektronik.
No.
Signal
Type
Description
1
OUT1A
SPST-A
Relay contact A
2
OUT1B
SPST-B
Relay contact B
3
OUT2A
SPST-A
Relay contact A
4
OUT2B
SPST-B
Relay contact B
Table 4-3: General purpose output 1 & 2 connector description
A solid state relay ASSR-3210 from Avago Technologies is used for each general purpose output.
Voltage range: 18V to 30V.
Current range: 0mA to 200mA.
4.3.5
Trigger (f)
This 3 pole 3.5mm terminal connector allows plugging a cable entry plug like
691361100003
from “Würth
Elektronik”.
No.
Signal
Type
Description
1
TriggerOUT
OD (10k pull-up to 5V)
Trigger Output
2
TriggerIN
I (10V to 30V)
Trigger Input
3
GND
P
Power ground
Table 4-4: Trigger connector description
Note
The usage of this interface may depend on the firmware version.
4.3.6
RS232/RS485 (g)
This 3 pole 3.5mm terminal connector allows plugging a cable entry plug like
691361100003
from Würth
Elektronik.
