FlexPower ONVIF Wire-Free IP Camera
Model VNC4030-111PAS
Quick Start Guide
December 2018
©2018 Arlo Technologies, Inc. Arlo, Arlo logo, and Every Angle Covered are trademarks of Arlo
Technologies, Inc. Other trademarks are for reference purposes only.
Compliance
For regulatory compliance information including the EU Declaration of Conformity, visit
www.arlo.com/about/regulatory/
Arlo Technologies, Inc.
2200 Faraday Ave. Suite 150
Carlsbad, CA 92008 USA
www.arlo.com
www.arlo.com/support
Arlo International, Ltd.
Floor 3, Building 3 University Technology Center
Curraheen Road, Cork, Ireland
Package Contents
Magnetic wall
mount
FlexPower
Camera
Power cable
Power adapter
Outdoor mount
Rechargeable
battery
Outdoor mount
plate
Mounting screws
(2 sets of 2)
Drywall anchors
Step 2: Sync Your Camera With the Base Station
You must install the base station before you can sync the cameras.
1. Bring the camera within 2 to 4 feet (60 to 120 cm) of the base station.
2. Press the
Sync
button on the front of the base station for about two
seconds and release the button.
The base station camera LED blinks green.
3. Press the
Sync
button on top of the camera for about two seconds and
release the button.
The camera LED blinks blue. When the camera is synced to the base
station, the camera LED blinks rapidly to confirm sync.
Note:
The camera LED blinks amber if the sync is not successful. You must
repeat the sync process.
Step 1: Insert the Battery
1. Unlock the battery compartment by pressing and holding the latch.
2. Gently pull the battery door back to open the compartment.
3. Align the battery contacts.
4. Insert the battery.
5. Close the battery door.
Camera LED Guide
Camera
State
LED Behavior
General
Blinks blue once
. The camera was powered on.
Blinking blue and amber
. A firmware update is in progress. Do not
turn off the camera.
Off
. The camera is either powered off or is powered on and is
synced to a base station.
Syncing
Slow blinking blue
. The camera is attempting to sync to a base
station.
Fast blinking blue
. The camera is syncing with a base station.
Fast blinking amber
. The camera did not sync.
Charging
Fast blinking blue
. The camera is connected to power and is
charging.
Solid blue
. The camera is powered on and the battery is fully
charged.
Slow blinking amber
. The camera battery charge is low.
Fast blinking amber
. The power connection failed.
