Vario L3
Installation
Page | 22
Figure 14:
When inserting a PCI Adapter, first loosen or remove the three screws retaining the internal cover plate. The
PCI Adapter can then be slid into place, again carefully aligning the edge connector of the card with the riser
slot.
Figure 15: Adapter bracket tail
The Internal cover plate has a small notch at its end to allow the Adapter bracket tail to pass through. If the
cover screws are fitted then this notch is too close to the front metalwork, forcing the Adapter tail to foul on the
EMC gasket for the motherboard as shown below.
Figure 16: Potential Foul
