HawkEye 5500 Installation Guide - 6/23/2020
Introduction
Page
11
of
37
© 2020 Blue Sky Network, All Right Reserved.
CONTROL PANEL DESCRIPTION
The control panel contains several LED indicators for various purposes, and several buttons to control the
device’s operations. The descriptions below reference the photo above in accordance with the numerical
value.
POWERING UNIT ON VIA FRONT PANNEL
To power the unit on via the front panel, press and hold the power button unit the power light ceases to
blink and becomes solid.
NOTE
: The button for too short of a period will cause the unit to power off immediately.
SENDING A WAYPOINT
To send a waypoint, simply press the yellow waypoint button until you hear the beep. The transmit pending
light will then light up and the unit will immediately attempt to transmit a waypoint message.
ACTIVATING / DEACTIVATING EMERGENCY VIA FRONT PANNEL
1. Power / Charging Button / LED
Green = Power On & Good
Yellow = Battery < 50%
Red = Battery < 15%
Red Blink = Battery too Low to Run
Pink Blink = Unit in Bootloader Mode
Blinking = Charging
2. Signal Status LED
Green = Unit in Cellular Mode
Purple = Unit in Iridium Mode
Yellow = Poor Signal
Red = Bad Signal
Red Blink = No Network Route
3. Message Waiting LED
Green = Unread Message
4. Action Button & Transmit LED
Green = Message Pending Transmit
Blinking = Message Transmitting
5. Emergency Button / LED
Red Blink = Emergency Requested
Red Solid = Emergency Active
