Blue Diamond HD 2 Series, Руководство по эксплуатации и обслуживанию

Страница: 17 / 52

Job Site Tips / Recommendations Cont’d
Processing Tips
Gravel Processing - Rework driveways by
processing the existing compacted gravel. Set the
materials bar to regulate the amount of material
needed to flow through the
HD series 2 power
rake
. This may be done by removing or adding
spacers on the gauge wheels spindles. Also
on 3-point models the draft arms may be
adjusted to pitch the hitch which in turn will pitch
the rotor.
Leaving the material side shields on will trap and
collect the material. But if you need to make more
aggressive contact remove the shields. Also
removing the ditch side end shields will let the
rotor teeth make more contact with the soil/gravel.
Also removing the end shields/material shields will
prevent damage to the shields if contact is made
with ledge rocks, dead heads, roots and other sub
surface objects.
Wet Conditions - Open the material bar allowing
material to flow over the rotor. This allows the
material to fluff up and airs out the soil.
Setting Grade - Loosen up the material, start
setting a 2” seed bed.
Blending existing and processed lawn
together - Set the gauge wheel on one side of the
machine in the up position, allow the rotor to
overlap the existing lawn 6” to 12”. Outside rotor
teeth will be just touching or not touching surface,
while other side will be touching and processing
the material bringing the two surfaces together.
Dimpling - If water pockets are required for water
control. Set the rotor teeth just off the surface and
let the teeth dimple the surface.
Final Grade - Set the rotor teeth so they are just
touching the surface. This will collect the small
rock and debris (this is raking action).
Blue Diamond® Attachments 17