Blue Bird VISION 2011, Руководство водителя

Страница: 50 / 140

VISION
D R I V E R S H A N D B O O K
48
Driver’s Seat, Standard
The standard Driver’s seat in the Blue Bird Vision is mounted on a spring-loaded ped-
estal. Several manual adjustments are provided for maximum control, safety and
comfort:
Height control. The telescoping cylindrical tubes of the seat base enclose a coil
spring which pushes the seat height upward when the seat is not loaded. A hand
operated lever on the right side of the seat mount latches the seat into one of sev-
eral height increments, and tightening the adjacent hand-operated knob locks the
seat securely at the current height. To change the height, crouch beside the seat and
loosen (counterclockwise) the knob on the seat base. This allows the spring in the
seat base to raise the seat when the lever is raised. Raise the lever and hold it while
pushing the seat down to the desired height. Release the lever. Raise / lower the seat
to ensure it snaps into the nearest of the preset notches. Then tighten the locking
knob securely.
Back Tilt control. Turn the large knob located at the bottom of the left side of the
seat back, where the seat back attaches to the seat bottom.
lumbar support. The knob located at mid height on the right side of the seat back
tightens / loosens a lumbar support built internally into the seat back.
seat Bottom Fore / Aft slide. A lever located under the front edge of the seat bottom
releases the seat track allowing the seat to be adjusted fore or aft. While seated, pull
the lever toward the left. Slide the seat fore or aft to the desired position and release
the lever. Slide the seat slightly to ensure the lever latches into one of its locking
notches.
seat Bottom length. Under the front edge of the seat bottom, directly above the
slide release lever is a handle which allows the seat bottom to be pivoted forward,
effectively “lengthening” the seat bottom for Drivers with longer legs. To move the
seat base to the forward position, stand beside the seat. Grasp the front handle with
your right hand, and the side of the seat bottom with your left. Lift the seat slightly
and pivot it forward. Then press it down firmly into position.
Pivoting the seat bottom forward in this way also clears the seat bottom from
the seat back, allowing the bottom to be hinged forward to gain service access to
the seat pedestal mechanism.
driver lap & shoulder Belt
To use the seat belt/shoulder harness, pull out an adequate amount of webbing and
engage the buckle. The retractors will pull the harness snugly into place. You may ad-
just the height of the shoulder harness by positioning the bracket to the most comfort-
able level. The buckle can be released by pressing on the button at the center.
[WARNING]
The driver’s seat belt should be worn any time the bus is moving.
The upper mount of the shoulder harness is adjustable for
proper position across the Driver’s chest. Press down on
the release button and slide the strap mount to the desired
height. Release the button and ensure that the slide latches
into the nearest preset notch.