Blower Engineering Tri-Lobe TL Series, Инструкция по установке, использованию и обслуживанию

Страница: 12 / 23

10 Blower Engineering Instructional Manual
7.0 Troubleshooting
Cause Remedies
7.1 Inlet pressure different from the design value
Inlet piping is clogged Check piping and remove obstruction
Rotation speed is not the same as design RPM Check rotation speed and reset to design RPM
7.2 Outlet pressure different from the rated value
Outlet piping is clogged Check piping and remove obstruction
Rotation speed is not the design RPM Check rotation speed and reset to design RPM
7.3 Outlet temperature different from the rated value (stop the blower immediately)
Inlet temperature different from design value Check inlet temperature and reset to rated value
Compression ratio is not the same as the Check inlet and outlet pressures and reset to
design conditions rated values
Rotors are worn Measure clearances of rotors
7.4 Power absorbed different from the rated value
Differential pressure different from rated value Check the inlet and outlet pressure and reset to
rated value
Speed of rotation is not the same as rated value Check the speed of rotation and reset to
rated value
Incorrect electrical connection Check electrical system
Rotors making contact Stop blower immediately (see paragraph 7.3)
7.5 Loss of oil
Drive shaft seal is worn Replace the drive shaft seal
Oil drain and level plugs gaskets are worn Replace the gaskets
Oil level sight glasses are broken Replace sight glasses, fill with oil
7.6 High oil temperature
Oil level too high Reset correct oil level (see paragraph 6.1.1)
Oil too viscous Use less viscous oil
High differential pressure See paragraph 7.2
Oil produces foam Change the type of oil
7.7 Unusual noises and/or vibrations (stop the blower immediately)
Differential pressure exceeds rated value Check inlet and outlet pressures and reset to
rated values
Discharge temperature exceeds rated value see paragraph 7.3
Rotors making contact Stop blower immediately, measure gear and
rotor clearances
Scale on internal parts Thoroughly clean the rotors and compression
chamber
Bearings are worn Measure bearing clearances and, if necessary,
replace them
Intake of foreign particles Remove foreign particles, clean the inside of
the blower