INSTALLATION (continued)
3
NOTE:
This equipment must be
installed to comply with
applicable federal, state and
local plumbing codes and
ordinances.
WARNING:
SHOCK HAZARD
Brewer must be properly
grounded to prevent possible
shock hazard. DO NOT
assume a plumbing line will
provide such a ground.
Electrical shock will cause death
or serious injury.
IMPORTANT:
Supply power must match
nameplate for voltage and
phase. Connecting to the
wrong voltage will damage the
brewer or result in decreased
performance. Such damage is
not covered by warranty.
IMPORTANT:
The ground prong of the plug is
part of a system designed to
protect you from electrical shock
in the event of internal damage.
Never cut off the ground prong
nor twist a blade to fit an
existing receptacle. Contact a
licensed electrician to install the
proper circuit and receptacle.
NSF requires that the brewer be able to be moved for cleaning
underneath. A flex line or loops of copper tubing will satisfy this
requirement. See Figure 2 below.
In some areas, local codes require a backflow preventer (check
valve) to be installed on the inlet water line. If a backflow
preventer is used, you must install a
water hammer arrester
in
the incoming line, between the backflow preventer and the
brewer inlet, as far away from the brewer as space will allow.
This will relieve the excessive back pressures that can cause
faucet leaks and solenoid malfunctions.
IMPORTANT:
Tank must be full of water before connecting brewer to electrical
power. Heating elements will be damaged if allowed to operate
without being fully submerged in water. Damage caused by
operating the brewer without water in the tank is
NOT COVERED
BY WARRANTY
.
ELECTRICIAN’S INSTALLATION INSTRUCTIONS
REFER TO ELECTRICAL SPECIFICATIONS provided in the
Owner's Manual, specification sheet, and on the nameplate.
Some models are equipped with a cord and plug. They require:
1. A circuit that meets or exceeds the electrical requirements
2. A properly installed and grounded receptacle configured
to match the brewer plug.
Some models are designed to be connected directly to the
electrical circuit. They require:
1.
A circuit that meets or exceeds the electrical requirements
2.
Conduit and fittings that meet applicable electrical codes.
3. The ground lug of the brewer must be connected to a suitable
electrical ground.
Water Supply Installation
NEMA 5-15R
RECEPTACLE
NEMA 5-15P
PLUG
GROUND
PIN
Typical Plug/Receptacle
Configuration
Содержание Gourmet 1000
