OPERATION
Fig. 4 Brewer Operation Diagram
START-UP
For initial start-up, or if the brewer has not been used for an
extended period of time:
Be sure spray disks and brew gaskets are properly installed in both
brew heads.
Be sure the water supply is properly connected and the water
supply valve is turned
ON
.
BEFORE
plugging the brewer into a receptacle, or otherwise
connecting brewer to electrical power
THE WATER TANKS MUST
BE FILLED
. Place an empty container under each brew head.
Lift the pour-over covers and pour tap water into the pour-over
RSHQLQJVXQWLOZDWHUÀRZVIURPERWKEUHZKHDGV:KHQZDWHUVWRSV
dripping from the brew heads, empty the containers. This will
require about 3 full 64 oz. decanters of water per side.
Once both tanks are full of water, connect the brewer to electrical
power. The heating elements will begin heating the water in the
WDQN:KHQWKHZDWHUKDVUHDFKHGWKHSURSHUWHPSHUDWXUHWKH
“READY T
2%5(:´OLJKWZLOOJOR
w.
A.
IMPORTANT:
Tanks must be full of
water before connecting
brewer to electrical power.
Heating elements will be
damaged if allowed to
operate without being fully
submerged in water.
Damage caused by
operating the brewer
without water in the tanks
is
NOT COVERED BY
WARRANTY
.
6
SOLENOID W/ FAUCET BYPASS (RIGHT SIDE)
SOLENOID (SINGLE - LEFT SIDE)
INLET FITTING
FAUCET WATER
HEATING COIL
(RIGHT SIDE ONLY)
WATER TANK
FAUCET SHUT-OFF
(RIGHT SIDE ONLY)
TANK VENT TUBE
HOT WATER FAUCET
(RIGHT SIDE ONLY)
BASIN
TIMER
BREW
HEAD
BREW
CHAMBER
BRAIDED HOSE
FAUCET SUPPLY
(RIGHT SIDE ONLY)
IL1718
625 p/n 2M-75873 8792, 8793 Dual Coffee Brewer
