Blonder tongue 6522-PIL, Инструкция по эксплуатации

Страница: 12 / 40

12 EQAM-420A
Instruction Manual
5.1 Accessing the Unit via a Web Browser
You must complete the steps described in Section 4 before proceeding as follows:
(1) Open a web browser on your computer (Internet Explorer 7 or higher is recommended) and enter the following URL
address (http://172.16.70.1). The "Login Screen" (Figure 5.1) will appear.
FIGURE 5.1 – Login Screen
(2) Enter the following case-sensitive factory-default Username and Password, and click on the "Submit" button.
NOTE: When logged in as Admin, the user has read and write permission. Only one Admin can
be logged in at a time. When logged in as Guest, the user has only read permission. Up to four
Guests can be logged in simultaneously.
Username = Admin (case-sensitive)
Password = pass (case-sensitive)
- OR -
Username = Guest (case-sensitive)
Password = pass (case-sensitive)
Monitoring and configuration of the unit is achieved via a series of web pages as described in the Sections below. The
following read-only information is displayed in a “page header” – in blue color – on top of each web page:
ESN: unit’s Serial number
headend name: a user-defined field to make identification easier
Temperature: temperature of unit’s chipset – SNMP trap threshold is set at 140° F.
Uptime: time elapsed since last time the unit was turned on
Location: a user-defined field to make identification easier
As shown in Figure 6.1, under the blue “page header” the following Primary tabs will appear:
• Primary tab “Main” includes the following sub-tabs: Status, Stream Info (applicable to MPTS Mode only), QAM
Config, Diagnostics, Mode, and Refresh.
• Primary tab “Network” doesn’t include any sub-tab.
• Primary tab “Management” includes the following sub-tabs: SNMP Traps, and Refresh.
• Primary tab “Time” doesn’t include any sub-tab.
• Primary tab “Error Log” doesn’t include any sub-tab.
• Primary tab “Config” doesn’t include any sub-tab.
• Primary tab “Logout” doesn’t include any sub-tab.
Each Primary and sub-tab is described in the subsequent Sections.
Section 5 – Quick Configuration