7
Installation
Oven Assembly
Stacking two CTBR-AP’s or a CTB biscuit oven on top
of a CTBR-AP
NOTE: When stacking a CTBR-AP and CTB biscuit oven
with the FAST timer, the CTB must be placed on
top.
1. Assemble the lower section to the stand.
2. Place the stainless steel crown trim on top of the low-
er section.
3. Remove the side control compartment cover and
open the front control panel on the upper section.
4. With a tool, punch out the knock-outs in the oven bot-
tom near each corner of the upper section.
5. Punch out the knockouts in the top of the lower sec-
tion near the left hand corners.
6. Lay the upper section on its back. Attach the self ad-
hesive gasket tape to the front and side edges on the
bottom of the unit.
7. Set the upper section on the lower section.
8. Align the front and rear bolt holes of the upper section
with the bolt holes in the bottom section.
9. Insert a bolt and washer from the top down through
each of the two holes.
10. Place a nut and washer on each of the bolts and tight-
en securely.
11. Replace the oven side control compartments, and
close the front control panels on both oven sections.
12. Place the top cap on top of the upper unit.
Figure 4
Upper Section
Lower Section
Top Cap
Crown Trim
Gasket
Tape
Double stacked CTBR-AP shown
