BLiss tuBs
save these instructions
30
© 2015 - 2017 Bliss Walk-in Bathtubs. All Rights Reserved.
aPPenDix c: reverse Drain instaLLation
reverse Drain instaLLation instructions
All plumbing work should be done by a licensed professional contractor. Bliss Tubs does not warranty any part of the
installation and is not responsible for any damages due to improper installation. It is the installer’s responsibility to
ensure that the installation will conform to all applicable state and local codes.
These instructions describe what to do when the existing drain location is on the opposite side than the drain location
on the new walk-in bathtub.
1.
Install drain shoe piece from the Bath Waste & Overflow kit with the outlet facing the seat of the tub.
2.
Connect the “reverse drain fitting” to the drain shoe using a small piece of 1
½
” PVC. NOTE: The “reverse drain
fitting” consists of a 1
½
” PVC wye-tee connected to a 1
½
” PVC street 45 degree ell fitting and is included with the
tub on request.
3.
The output of the reverse drain fitting is connected to the door drain connector and then a section of 1
½
” PVC pipe
that will lead back to the p-trap which should be located somewhere underneath the seat section of the tub.
Photo: view of reverse drain plumbing separate from bathtub.
Drain Shoe
Reverse Drain Fitting
Door Drain
Connector
From Overflow
