PAGE 22
OM-9703
Date Printed: Thursday, July 05, 2007
Revision Date: March 6, 2006
9703 - REPLACEMENT PARTS LIST
PART NAME:
PART #
1. Robertshaw Gas Valve
0718A
Honeywell Gas Valve
0720
2. Fan
0719B
3. Main Burner Switch
0725A
4/5/6. Log Set (3 piece)
0813
7. Piezzo Push Button Igniter
0737
8. Shroud Trim Long (Insert only)
0758B
“
“ Short
“
0767
9. Fiber Embers
0745
10. Fan Cord
Z0158
11. Front Decor - Gold
Z9732G
12. Pedestal
9748
13. Main Gas Line 3/8”x12” Flex
0838B
14. Pilot Line 1/4”x30” Flex
0839D
15. Front Burner Gas Line 36” Flex
0838C
16. PSE Pilot Assembly. OBSOLETE
Use Robert Shaw (Abrev. RS)
17. Robert Shaw-Pilot Hood
c/w Orifice & Electrode
0721VC
18. Robert Shaw Electrode
c/w 24” Wire
0738B
19. Thermopile Generator; use with
Robert Shaw or PSE
0721A
20. LPG Kit: 0-2000ft
Z0748P
21. LPG Kit: 2000-4500ft
Z0748P/H
22. Nat Regulator (RS)
0747
23. LPG Regulator (RS)
0734
INSERT
1. Remove 7/8” gasket
2. Using a nut driver remove all 14 6/32 nuts and washers from around the door
3. Before removing glass retainers note there are two different retainers. One for the bottom and one for the top. The top
retainer has a long notch across the bottom of it and the bottom retainer is one solid piece. It is important to make sure that
the top retainer is used for the top of the door. If it is not it will void your warranty on the door.
4. Remove glass retainers (4)
5. Remove 2 seal plates from frame of door.
6. Remove channel tape from around 3 pieces glass
7. Remove gold door from work area and completely clean all debris to prevent gold door from being scratched.
8. Place new glass flat and allow approx. 1/8” space between outside pieces and center.
9. Starting at a corner and using channel tape (5/8”) , peel backing off of tape and in small sections at a time, wrap around the outer
edges of glass making sure spaces are equal between outer glass and center (1/8”).
10. Taking gold door place seal plates onto the two bends of the door making sure to center evenly.
11. Place glass into frame of gold door make sure to center spaces with the bend of the door where seal plates are aligned.
12. Clean glass retainers of all residue. Place bottom retainer in proper section and top retainer in top part of door. Next, place two outside
retainers on door.
13. When applying nuts and washers start in center of either top or bottom retainer and work your way out. This should allow for easier
application. Do not tighten nuts until all are on and centering of glass and retainers is adequate. Do not over tighten.
14. Apply cement in small fine line around the inside ledge of glass retainers.
15. Starting between the door hinges put new 7/8 gasket on, pressing it into the corners and bends of the door. Cut gasket 1/8” from end
and push into closing end. Press gasket securely into place.
PART NAME:
PART #
24. Rheostat (fan speed control)
Z0136A
25. F200 Snap Disc (Fan Switch)
1144B
26. L200 Snap Disc (Spill Switch)
1143
27. Wall Thermostat
0736
Glass Replacement Procedure
