Blaupunkt LONDON RDM 43, Руководство по эксплуатации

Страница: 16 / 20

33
London RDM 43
DE
UT
S
C
H
EN
GLI
S
H
IT
A
L
IANO
POR
T
UG
UE
S
NE
DE
RL
AND
ESP
A
G
ÑO
L
SVEN
SK
A
F
RANÇAI
S
●
Press the rocker switch /
F
until
‘COLOUR’ lights up on the display
C
a.
For changing the colour,
●
press << / >>
E
,
and the display colour will change.
For storing this adjustment,
●
press the DSC button
4
once again.
This function can be adjusted separately for
KeyCard 1 and 2.
Theft Protection by Code LED
As a preventive measure, you can let a light-
emitting diode (LED)
G
blink in the car’s
interior when it is parked.
For modifying the setting,
●
press the DSC button
4
.
The display
C
a gives you “BEEP ON”
or “BEEP OFF”.
●
Press the rocker switch /
F
until
‘LED’ and a number light up on the
display
C
a.
●
Via the rocker switch << / >>
E
, you
can adjust the following:
LED 0 -
Blinking is off.
LED 1 - LED only blinks if the car
radio is connected via the
ignition.
LED 2 - LED only blinks if the car
radio is not connected via
the ignition.
This function can be adjusted separately for
KeyCard 1 and 2.
Loudness
Since your in-car sound quality is influenced
by the type of the installation (amplifier), the
type and arrangement of the loudspeakers,
and the vehicle itself, you may individually
programme at which level you want the set to
start boosting the basses (loudness).
For changing this loudness level,
●
press the DSC button
4
.
The display
C
a gives you “BEEP ON”
or “BEEP OFF”.
●
Now press the rocker switch /
F
until ‘LOUD’ and a number between 1
and 6 illuminates on the display
C
a.
●
With the rocker switch << / >>
E
you
can match the above mentioned loud-
ness level to your personal require-
ments.
For memorizing this adjustment,
●
press the DSC button
4
once again.
This function can be adjusted separately for
KeyCard 1 and 2.
Preset Naming
When you select a station, the display C a
will give you the frequency and for RDS
stations also the station name later on, e.g.
91.3
BBC3. You can replace the frequen-
cy indication of all preset stations without
RDS code by entering an 8-digit name.
Note the following:
The stations must be stored on the storage
levels I-III.
For entering a station name, proceed as
follows:
●
Press the DSC button
4
.
The display
C
a gives you “BEEP ON”
or “BEEP OFF”.
●
Press the rocker switch /
F
until
‘PRESET’ is illuminated on the display
C
a.
●
Choose the desired station (via the
preset buttons), for which the name is
to be entered.
The frequency is indicated on the display
C
a.
The first dash is blinking. For changing it and
entering the desired character:
●
Press the rocker switch << / >>
E
on
the right continuously.
The display will give you one after the other
the capital letters (A-Z), the umlauts, the
special characters and the numbers 0-9.