Blanco FI905X, Инструкция по эксплуатации

Страница: 36 / 43

36
By touching again the M key, the end of cooking time appears together with the "End" writ i ng.
How to change the current time or the sound level
With the programmer in standard mode, the (2) symbol is on, touch together the - and + keys
for at least 2 seconds or anyway up to see the dot (3) blinking
.
To update the hour on the display: touch the + or - keys.
To change the sound level: touch the M key. On the display appears the writing:
Ton..followed by a number . Select with the - key your favorite sound level .
Note: number 1 is referred to the highest sound level . The available levels are 3.
Attention: Power cut causes the l oss of any program, even the clock; that means the
programmer will have to be set again .
CLEANING THE APPLIANCE
CATALYTIC SELF - CLEANING LINERS
The self-cleaning oven differs from the standard one in the fact that its internal surfaces are
enamelled with a special microporous material which absorbs and eliminates the greasy particles
during the cooking. In case of spillage of greasy liquids, the self-cleaning action becomes not efficient;
therefore it will be necessary to clean the oven properly. Proceed in the following way: (a) wipe a
humid sponge on the grease stains; (b) heat up the oven to the maximum temperature; (c) wait 5
minutes and then switch off the oven
; (d) wait until the oven gets cool again; (e) wipe again the humid
sponge on all the surface. Do not use detergent in any case.
WARNING: Before cleaning the appliance, it should be disconnected from the power
supply and turn off the main gas feeder valve.
Cleaning the ceramic hob
Before carrying out any operations, disconnect the appliance from the electricity supply.
The ceramic hob must be cleaned regularly, preferably after each use, when the residual heat
warning lights have gone out.
Any marks left by the use of pans with aluminium bottoms can be wiped off with a cloth dipped in
vinegar.
If burnt residues are left after cooking, remove them with the scraper provided, rinse with water and
dry thoroughly with a clean cloth. Regular use of the scraper considerably reduces the use of
chemicals for daily cleaning of the hob.
In any case, abrasive or corrosive cleaners (e.g. powder products, oven cleaner sprays, stain
removers and metal scouring pads) must never be used.
Any liquid that overflows from pots must always be removed using a rag.
Cleaning the enamelled parts
To maintain the original features of the enamelled parts they should be cleaned frequently with
soapy water. Never use abrasive powders. Do not leave acidic or alkaline substances on the
enamelled parts (vinegar, lemon juice, salt, tomato sauce, etc.) and do not wash the enamelled parts