EN
12
Tail Assembly (T)
1. Slide the tail pushrod guide onto the tailboom. The
guide should be located approximately in the center
of the tailboom.
1. Remove the 3x16mm socket head cap screw and
linkage ball from the tail pitch lever assembly
and re-install them using medium thread-locking
compound. Ensure the thread-locking compound
does not contact the lever assembly bearings.
2. Attach the tail rotor pitch lever assembly to the
right side tail plate using two 2.5x8mm button head
screws and medium thread-locking compound.
3. Attach the right tail plate assembly to the tailboom
mounts using four 3x10mm socket head capscrews,
machined washers and medium thread-locking
compound. Do not fully tighten.
4. Attach the left side tail plate/fi n to the tailboom
mounts using four 3x10mm socket head capscrews,
machined washers and medium thread-locking
compound. Do not fully tighten.
5. Insert the tail belt guide bearing between the tail
plates and attach with two 2.5x8mm socket head
capscrews and medium thread-locking compound.
6. Insert the rear spacer post between the tail
plates and attach with two 3x10mm socket head
capscrews, machined washers and medium thread-
locking compound.
2. Slide two rear tailboom mounts over the tailboom.
3. Attach the mounts using two 3x6mm button head
screws per mount and medium thread-locking
compound, into the holes on either side of the tailboom.
4. Loosely insert one 3x10mm socket head capscrew
with medium thread-locking compound in the top of
each mount as shown.
Step T2
Step T3
