Blade Blade mSR S, Инструкция по эксплуатации

Страница: 9 / 29

9 EN
D/R & Expo
Chan
Sw Pos D/R Expo*
AILE
0 100 INH
1 75 INH
ELEV
0 100 INH
1 75 INH
RUDD
0 100 INH
1 75 INH
Timer
Down Timer
5:00
Switch THR CUT
ADJUST LIST
SETUP LIST
DX6i
TRAVEL ADJ
Channel
Travel
THRO 100/100
AILE 100/100
ELEV 100/100
RUDD 100/100
GEAR 100/100
PITC 100/100
REVERSE
Channel
Direction
THRO N
AILE N
ELEV N
RUDD N
GEAR R
FLAP N
Modulation Type
AUTO DSMX-ENABLE
Model Type
Acro
D/R COMBI
D/R SW AILE
Flight Mode Operation
Gear Sw: Pos 0, Elev D/R Sw: 0 or 1 = Stability, Low-Angle Mode
Gear Sw: Pos 1, Elev D/R Sw: 0 = Stability, High-Angle Mode
Gear Sw: Pos 1, Elev D/R Sw: 1 = Agility Mode
Mixing
MIX 1 ACT
GEAR > GEAR ACT
RATE D 0% U –100%
SW GEAR TRIM – INH
MIX 2 ACT
GEAR > GEAR ACT
RATE D 0% U +100%
SW ELE D/R TRIM – INH
FLAPS
FLAP ELEV
NORM 100 0
LAND 100 0
* Use of "Expo" is not necessary for successful fl ight of the mSR S. The pilot may
adjust this setting to tailor the sensitivity of the helicopter around neutral if desired.
Panic Mode Operation
Gy ro Switch:
Pos 0 = Panic Mode Off
Pos 1 = Panic Mode On
Once bound, the LED in the helicopter should glow blue for fl ight modes 0 and 1
(Stability, Low-Angle and High-Angle Modes), and glow red for fl ight mode 2 (Agility mode).
If the LED glows blue in all three fl ight modes, channel 6 has not been reversed correctly.
Use the directions above to reverse channel 6.