6
SURF MODE
The Surf Mode allows the system to be armed
or disarmed using just the key and override
switch. While in surf mode the transmitter may
be safely left at home or inside the vehicle’s
trunk when engaging in an activity that may
damage the transmitter such as surfing,
swimming, white-water rafting, going over
Niagara Falls in a barrel.
To arm the system in surf mode:
1. Make sure ignition is on and all doors are
closed.
2. Press valet switch 3 times.
• The siren will chirp once.
3. Turn ignition off and exit the vehicle.
• After 20 seconds the system will arm.
If the door, hood, or trunk zone is triggered, the
lights will flash but the siren will be delayed for
20 seconds allowing time to enter the
Emergency Override or PIN code.
To disarm the system in surf mode follow the
steps for Emergency Override, or PIN code
override if programmed.
OPTIONAL REMOTE START FEATURES
Important: Only start the vehicle in a well
ventilated area. Do not use in a closed garage
or indoors. Be sure to familiarize yourself with
all features prior to using the remote start.
REMOTE STARTING THE VEHICLE
To remote start the vehicle:
1. Press and hold button 2 for level shift.
2. Press button 2 again.
• The parking lights will begin flashing (or
remain on depending on programming).
• Approximately 2 seconds later the
system will attempt to start the vehicle.
• Once the car has started, the heater or
air conditioner will turn on and run for
the pre-programmed time. If the engine
fails to start on the first attempt, it will
attempt to start 3 more times. If the
vehicle fails to start after a total of 4
times the system will shut down.
To drive the vehicle after Remote Starting:
Unlock the door by pressing button 2 on the
remote transmitter. Enter vehicle, turn
ignition key to the on position
NOTE: Do not turn the key to the start position
as the engine is already running.
Once the ignition key is turned on, press the
brake pedal and shift the car into the proper
gear and you may now drive the vehicle.
NOTE: If brake pedal is pressed prior to turning
on ignition, engine will turn off.
REMOTE ENGINE SHUTDOWN
If the vehicle has been remotely started and
you desire to turn the vehicle off, simply press
and hold button 2 for level shift, then press
button 2 again. After the motor has turned off
the doors will relock. This feature must be
programmed during installation.
STOP AND GO
The Stop and Go feature allows the vehicle to
remain running without use of the ignition key
during short stops.
To activate the Stop and Go feature:
1. Make sure the engine is running.
2. Press and hold button 2 for level shift.
3. Press button 2 again.
4. Turn ignition off.
• The doors will unlock.
• The dome light will turn on.
• The engine will remain running.
5. Exit the vehicle and lock the doors using
transmitter button 1.
7250 rev 2 9-23.qxd 9/24/2004 12:54 PM Page 6
