2
High-Current Wire Connections:
• RED WIRE #1 -Main power input; using the
supplied inline fuse holder, connect directly to
the vehicle’s battery or alternate power source
with a minimum 30 Amp supply.
• RED WIRE #2 - Secondary power input; using
the supplied inline fuse holder, connect directly
to the vehicle’s battery or alternate power
source with a minimum 30 Amp supply.
Note: If not connecting directly to the vehicle’s
battery, it is recommended to use separate
power sources (minimum 30 Amp each) for each
red power wire.
• BROWN WIRE - Second ignition output;
connect to the wire that sw12V and
does not drop out during cranking. This wire
may be optionally programmed for use as a sec-
ond accessory wire or second starter wire. (see
Programmable Features)
• ORANGE WIRE - Main accessory output;
+12V output to heater and/or air conditioning
system. For cars with more than one accessory
wire add a relay(s) to power the extra accesso-
ry wire(s) or program the BROWN wire for
second accessory.
• YELLOW WIRE - Main ignition output;
connect to the main ignition wire that switches
+12 V and does not drop out during cranking.
• VIOLET WIRE - Starter output; connect to the
vehicle’s starter wire.
Main Harness:
• GREEN/WHITE WIRE - Brake switch input
wire. Connect this wire to the brake switch wire
that pr12V when the brake pedal is
pressed. This is a safety input and
must
be
connected on all installations.
• BLACK/GRAY WIRE - Tachometer input. If
the Smart Start feature fails to start properly,
connect the BLACK/GRAY wire directly to the
vehicle’s tach wire or negative fuel injector wire,
and program Step #20 to Tach Start.
• WHITE/RED WIRE - Auxiliary 2 output (-)
500mA. Connect to a relay or module for an
optional feature such as power window activa-
tion or remote start, etc. This output may be
programmed for momentary, timed, or latched
operation.
• BLACK/WHITE WIRE - Dome Light output
(-) 500mA. Connect to a relay to activate the
vehicle’s dome light. NOTE: The dome light
relay’s output is usually connected to the same
wire used for the door trigger input (See
GREEN and VIOLET door trigger wires).
• YELLOW WIRE - +12V Ignition input.
Connect to a main ignition wire at the ignition
switch harness.This wire shows +12V when the
ignition is on and while cranking. The voltage
must not drop when the car is starting.
• BLUE/YELLOW WIRE - Glow Plug Light
input (+). For diesel engine vehicles connect to
the glow plug wire in the instrument cluster
that shows +12V when the the glow plug (wait-
to-start) light is on, then shows ground when
the light turns off. For vehicle’s equipped with
a positive glow plug wire (shows ground when
the wait-to-start light is on) a relay is required.
(see Relay Diagrams)
• BLUE/WHITE WIRE - Passenger Unlock
output (-) 500mA. Connect to an optional relay
to unlock the passenger doors when the system
is configured for Driver Priority Unlocking.
• BLUE/ORANGE WIRE - Ground When
Running Output (-). This wire provides a ground
when the remote start is engaged to activate an
optional factory security bypass module.
• BLACK WIRE - Ground input (-). Connect to
a solid chassis ground that is clean and free of
paint or dirt.
Содержание 6150
Страница 15: ...15 INSTALLATION NOTES ...
