Part
II:
Setting Up
The
Log
Splitter
14
7.
Check belt tension
Check the belt tension by pressing down on the
belt with your finger (Fig. 27).
If
the belt is too loose, it must be tensioned. To do
so, loosen the four bolts, which hold the engine plate
incl. the engine to the housing (not the bolts that
secure the engine. These are loosened, to adjust the
pulley alignment). Figures 28 and 29 show the bolts
to be loosened.
To adjust the
tension, loosen the lock nuts and twist the
adjusting screws (see Figure 30).
Depending on the rotation of
the bolt, the engine plate moves
upwards or downwards in the slot and
the belts are tensioned or loosened.
After a successful correct alignment,
screw the lock nuts back on again and
Fig. 26 Loosen slightly, then shift engine
Fig. 27 Correct tension
Max.
bending
of
10
Fig. 28 Loosen rear bolts
Fig. 29 Loosen front bolts
Fig. 30
Shifting the housing with engine
Tension
Loosening
Содержание GTE-2000
Страница 1: ...GTE 2000 WOOD CHIPPER Instruction Manual Table of Contents ...
Страница 3: ...Part I GeneralSafety Rules 2 Safety Labels Found on Your Unit ...
Страница 16: ...Part II Setting Up The Log Splitter 15 tighten the plate again using the four bolts ...
Страница 24: ...x Part II Setting Up The Log Splitter 23 Fig 63 Open choke and fuel shut off Choke Fuel tap ...
