18
BRAVO.
INSTRUCTION MANUAL
Rudder control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
C/A glue.
Pen.
Mark a hole.
5. Put the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90 de-
gree to the horizontal stabilizer.
Remove
covering.
Epoxy glue.
C/A glue.
6) When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the verti-
cal stabilizer mounting area. Apply epoxy to
the lower rudder hinge. Set the stabilizer in
place and re-align. Double check all of your
measurements once more before the epoxy
cures. Remove any excess epoxy using a
paper towel and rubbing alcohol and hold the
stabilizer in place with T-pins or masking tape.
Allow the epoxy to fully cure before proceed-
ing.
3. Mark the shape of the vertical on the left
and right side on the rudder using a felt-tip
pen.
4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rud-
der. Just as you did with the horizontal stabi-
lizer, make sure you only press hard enough
to cut the film, not the balsa rudder.
Pen.
RUDDER CONTROL HORN INSTALLA-
TION.
Содержание bravo 3d
Страница 27: ...27 BRAVO Instruction Manual...
