26
CHIPMUNK
-Item code BH44.
INSTRUCTION MANUAL.
Plastic parts of elevator
pushrod.
1) Cut out the switch hole using a modeling
knife. Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.
2) Secure the switch in place using the
two machine screws provided with the radio
system.
switch
Switch
INSTALLING THE SWITCH.
3. Position the battery pack and receiver
behind the fuel tank. Use two tie wraps to hold
the battery and receiver securely in place as
pictures below
1. Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2. Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape to
hold the foam in place.
INSTALLING THE RECEIVER AND BATTERY.
Cut.
Top side.
Elevator pushrod
Bottom side.
Rudder pushrod
Elevator pushrod
Bottom side.
C/A glue
