PIPER CUB- EP.
INSTRUCTION MANUAL
11
1) Using a modeling knife, carefully re-
move the covering from over the vertical sta-
bilizer mounting slot in the top of the fuselage.
3) Slide the stabilizer into place in the pre-
cut slot in the rear of the fuselage. The stabi-
lizer should be pushed firmly against the front
of the slot.
2) Draw a center line onto the horizontal
stabilizer. Then slide the horizontal into the
fuselage.
Center line
HORIZONTAL STABILIZER INSTALLATION.
Mark point
Top side
Remove covering
Bottom side
4) With the stabilizer held firmly in place,
use a pen and draw lines onto the stabilizer
where it and the fuselage sides meet. Do this
on both the right and left sides and top and
bottom of the stabilizer.
5) Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove the
covering from between them using a model-
ing knife.
When cutting through the covering to re-
move it, cut with only enough pressure to only
cut through the covering itself. Cutting into
the balsa structure may weaken it.
Remove covering
