Black Horce Model BH39, Инструкция по эксплуатации

Страница: 31 / 32

SPITFIRE.
INSTRUCTION MANUAL.
31

   2) Turn the airplane upside down. Place
your fingers on the masking tape and carefully
lift the plane .
CG
115 MM
*If possible, first attempt to balance the model
by changing the position of the receiver
battery and receiver. If you are unable to obtain
good balance by doing so, then it will be
necessary to add weight to the nose or tail to
achieve the proper balance point.

   1) We highly recommend setting up a
plane using the control throws listed.

 

2) The control throws should be measured
at the widest point of each control surface.

   3) Check to be sure the control surfaces
move in the correct directions.
CONTROL THROWS.

With the wing attached to the fuselage, all
parts of the model installed ( ready to fly), and
empty fuel tanks, hold the model at the
marked balance point with the stabilizer level.

Lift the model. If the tail drops when you
lift, the model is “tail heavy” and you must add
weigh* to the nose. If the nose drops, it is “nose
heavy” and you must add weight* to the tail to
balance.

   1) Completely charge your transmitter and
receiver batteries before your first day of flying.

   2) Check every bolt and every glue joint in
your plane to ensure that everything is tight
and well bonded.

 
 3) Double check the balance of the
airplane.

   4) Check the control surface.

 

5) Check the receiver antenna . It should
be fully extended and not coiled up inside the
fuselage.

   6) Properly balance the propeller.
We wish you enjoy.
PRE-FLIGHT CHECK.
Ailerons : 15mm up 15mm down
Elevator : 15mm up 15mm down
Rudder : 35mm right 35mm left
Ailerons Control