Black+Decker BCBLV36, Оригинальное руководство пользователя

Страница: 9 / 12

9
ENGLISH (Original instructions)
Always check that the mains voltage
corresponds to the voltage on the rating
plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
u
Use your BLACK+DECKER charger
only to charge the battery in the ap-
plaince/tool with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
u
Never attempt to charge non-recharge-
able batteries.
u
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be
placed in a well ventilated area when
charging.
$
The charger is intended for
indoor use only.
Read the instruction manual
before use.
Electrical safety
Your charger is double
insulated; therefore no earth
wire is required. Always check
that the mains voltage
corresponds to the voltage on
the rating plate. Never attempt
to replace the charger unit with
a regular mains plug.
u
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
1. On/Off switch
2. Handle
3. Lower Blow/Vac tube
4. Upper Blow/Vac tube
5. Stabilising wheels
6. Collection bag
7. Function selector
8. Battery
9. Charger
10. Strap
Assembly
@
Warning! Before assembly, make sure that
the appliance is switched off and the battery is
removed.
Blow and vac tube assembly (fig. A)
The blow and vac tube (3 and 4) must be assembled before
use.
u
Align the latches on the side of the blow and vac tubes.
u
Push the blow and vac tubes tube firmly into each other
until the latches click into place.
u
Push the assembled blow and vac tubes into the opening
on the blowe vac (4a) as shown in figure E
u
Secure with the screws (11) provided.
Note! The tubes should not be separated once assembled.
Fitting the stabilising wheels (fig. A)
The stabilising wheels slide onto the end of the lower blow and
vac tube (3) and are secured with the screw (11) provided.
As shown in figure E.
Charging the battery (fig. B)
The battery needs to be charged before first use and whenev -
er it fails to produce sufficient power on jobs that were easily
done before. The battery may become warm while charging;
this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging tem-
perature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 0 °C or above 40 °C.
The battery should be left in the charger and the charger
will begin to charge automatically when the cell tempera-
ture warms up or cools down.