Black Box WRT4000-ANT, Руководство пользователя

Страница: 78 / 144

724-746-5500 | blackbox.com
Page 78
Chapter 7: Configuring a MultiWAN for the WRT4000 Series Cellular Wireless Router
• Source Port (originating port, whether outbound or inbound): Type a port range. You may also type a single port number,
or this field may be left blank.
• Destination Address (goal IP address, whether local or remote): Type a network range for IP addresses (such as d.e.f.0/24,
where d.e.f represents the remote network). You may also type a single IP address, or this field may be left blank.
• Destination Port (goal port, whether outbound or inbound): Type a port range. You may also type a single port number, or this
field may be left blank.
• Protocol (IP transport protocol): Select a protocol from the list.
• Policy Assigned (required): Type a policy name that this rule will use, or set the value to default. The policy name must be listed
under Available Policies. If you select default, the rule uses the standard routing table.
• Equalize (how to apply loadsharing): If you want load balancing to cycle through the host networks, check the Equalize box. If
you do not check the box, the rule will use the standard routing table, and load balancing might be based on destinations.
c. When you have finished configuring this rule, select the Save button; then select the Back to Overview button to see the
MultiWAN Rule Configuration Summary Screen again (Figure 7-12).
Figure 7-12. MultiWAN Rule Configuration Summary Screen.
d. If you need to configure another rule for the multiWAN, return to step 7a.
e. After you have configured all the rules, confer with your network administrator to determine the order for the rules.
f. Use the arrows in the Sort column of the MultiWAN Rule Configuration Summary Screen to move a rule up or down in the list,
so that the rules are applied in the determined order.