Black Box TotalSwitch Series, Инструкция по установке и Руководство пользователя

Страница: 10 / 21

To install a TotalSwitch Module , remove the blank bracket covering
the slot where the module is to be installed by removing the two
screws located closest to the outside edge of the bracket.
NOTE: TotalSwitch Modules cannot be installed in Slot 1; this
disables SNMP for the Modular Concentrator’s NMS.
Next, slide the module into the chassis until it is seated securely in
the connector on the backplane. Secure the module to the chassis by
tightening the thumbscrews.
Figure 2.4 Installing a TotalSwitch Module in a Modular Concentrator
Hub
To complete the installation of a Modular Concentrator hub, refer
to the manual included with the hub for more information.
Installing
TotalSwitch
Modules in TotalSwitch 6
TotalSwitch Modules can be installed into any available slot in any
modular TotalSwitch 6 . Before installing a TotalSwitch Module in a
TotalSwitch 6 chassis, the resistor packs on the module must be
removed from the sockets on the rear of the PCB (lift the resistor pack
from the socket). Refer to the diagrams of the modules earlier in the
chapter for socket location.
NOTE: The sockets are located in the same general location on
TotalSwitch BNC/4.
To install a
TotalSwitch Module
, remove the blank bracket covering
the slot where the module is to be installed by removing the two
screws located closest to the outside edge of the bracket.
Next, slide the module into the chassis until it is seated securely in
the connector on the backplane. Secure the module to the chassis by
tightening the thumbscrews.
2.5