Black Box TotalSwitch Series, Инструкция по установке и Руководство пользователя

Страница: 6 / 21

Chapter 2
Hardware Installation
This chapter provides configuration and installation information for
TotalSwitch 6 10-Mbps Modules
(referred to as
Total Switch Modules
throughout the rest of this manual).
Jumper Settings
TotalSwitch TP/8, TotalSwitch FO/4 and TotalSwitch TP/4+FO/2
have several jumpers that may need to be configured. It is necessary
to power down the unit before adjusting the jumper settings.
NOTE: To change the settings once a TotalSwitch Module is
installed, it is necessary to remove the PCB from the chassis. To do
this, loosen the thumbscrews on the face of the chassis, then slide
the PCB out of the chassis. After configuration is complete, slide
the PCB back into the chassis and tighten the thumbscrews.
The following diagrams show the jumper locations and default
settings on the various TotalSwitch Modules .
NOTE: Ports are labeled on the PCB as well as on the front of the
module. The HDX/FDX jumpers at JA1 on TotalSwitch TP/8 are
numbered in reverse order (i.e jumper 1 corresponds to Port 8,
jumper 2 corresponds to Port 7, etc. Refer to the diagram of
TotalSwitch TP/8)
2.1