Black Box TotalSwitch Series, Инструкция по установке и Руководство пользователя

Страница: 9 / 21

Half-Duplex/Full-Duplex Jumpers
Each twisted pair and fiber optic port on a TotalSwitch Module can
operate in either Half-Duplex (HDX) or Full-Duplex (FDX) mode.
TotalSwitch Modules are shipped from the factory with HDX selected
on each port. HDX/FDX is selected on TotalSwitch Modules by
repositioning the shunts on the 3-pin, HDX/FDX jumper blocks on
the PCB.
The HDX/FDX jumper blocks on TotalSwitch TP/8 Modules are
located at position JA1 and labeled 1 - 8. The HDX/FDX jumper
blocks on TotalSwitch TP/4+FO/2 Modules are located at positions
JP5-10 (and labeled with the corresponding port). The HDX/FDX
jumper blocks on
TotalSwitch FO/4 Modules
are located at positions
JP4 for Port 1 (labeled Port 0 on the PCB), JP5 for Port 2 (labeled
Port 1 on the PCB), JP6 for Port 3 (labeled Port 2 on the PCB) and JP7
for Port 4 (labeled Port 3 on the PCB).
Select FDX by positioning the shunt over the top and center pins.
Select HDX (factory default) by positioning the shunt over the center
and bottom pins.
Factory Test Jumpers
The jumper blocks located at position JP1 on TotalSwitch
TP/4+FO/2 Modules and at position JP8 on TotalSwitch FO/4 Modules
are for factory test purposes only. These jumpers are configured at the
factory and should not be changed. The default setting is with the
shunt positioned on the top two pins.
Installing TotalSwitch Modules in Modular Concentrator
Hubs
TotalSwitch Module s can be installed into any available slot in any
collision domain on any Modular Concentrator hub (e.g.: Modular
Concentrator/12, Modular Concentrator/5 and Modular
Concentrator/2 ). For specific installation and operation information
on Modular Concentrator hubs, please refer to the manual included
with the hub.
NOTE: TotalSwitch Modules are not capable of being managed
even when installed in a Modular Concentrator hub using SNMP
managment.
2.4