Black Box ServSelect KV119A, Инструкция по установке и эксплуатации

Страница: 38 / 84

CHAPTER 4: OPERATIONS
37
a range of numbers separated by a dash or a combination of numbers with
commas and dashes. To enable all traps, type
ALL . To cancel the command,
press Enter .
- or -
To enable all SNMP traps, issue a Server SNMP Trap command with the
Enable and All parameters. In this case, the numbered list is not displayed.
SERVER SNMP TRAP ENABLE ALL
2. To disable SNMP traps, issue a Server SNMP Trap command with the
Disable parameter.
SERVER SNMP TRAP DISABLE
The SCPS will display a numbered list of traps that are currently enabled with
a prompt requesting you to select trap(s) to disable. Indicate the traps to be
disabled by entering a trap’s list number, several numbers separated by
commas, a range of numbers separated by a dash or a combination of numbers
with commas and dashes. To disable all traps, type
ALL
. To cancel the
command, press
Enter
.
- or -
To disable all SNMP traps, issue a Server SNMP Trap command with the Disable
and All parameters. In this case, the numbered list is not displayed.
SERVER SNMP TRAP DISABLE ALL
For more information, see
Server SNMP Trap command
in Chapter 6. The supported
traps are listed in Chapter 7.
To add or delete SNMP trap destination addresses:
1. To add an SNMP trap destination address, issue a Server SNMP Trap
Destination command with the Add parameter and the destination’s IP address.
You may defi ne up to four destination addresses, using separate commands.
SERVER SNMP TRAP DESTINATION ADD <
ip_address
>
2. To delete an SNMP trap destination address, issue a Server SNMP Trap
Destination command with the Delete parameter and the destination’s IP address.
SERVER SNMP TRAP DESTINATION DELETE <
ip_address
>
For more information, see
Server SNMP Trap Destination command
in Chapter 6.
To add, copy or delete port alert strings:
1. To add a port alert string, issue a Port Alert Add command, specifying the port
number and a 3-32 character string. You may defi ne up to ten strings for each
port, using separate commands. The alert string will only generate a trap if the