LINE command
The LINE command informs the user about the status of the connection over the physical line. Upon
entering the <C> parameter, the updating of the information on the screen will occur automatically with the
interval of 5…20 seconds according to the parameter set by the TRACETIME command:
Line Port Statistics
LOCAL REMOTE
-------------------------------------------------------------------------
5 sec Total 5 sec Total
Transmit Packets 0 0 0 0
Receive Packets 0 0 0 0
Receive Error Packets 0 0 0 0
Error Packet Rate, % 0.00 0.00 0.00 0.00
Receive Bytes 0 0 0 0
Transmit Bytes 0 0 0 0
Average Speed, kBps 0 0 0 0
-------------------------------------------------------------------------
Software Version 1.2
Link Down Down
Line Speed, kBps 272 272
Signal Level, dBm 0.0 0.0 0.0
Far-End Level, dBm 63.0 63.0 0.0
Noise Level, dBm -16.0 -16.0 0.0
NTU_PM_S09_P1>
ETH command
The ETH command informs the user about the status of the connection over the Ethernet port. Upon
entering the <C> parameter, the updating of the information on the screen will occur automatically with the
interval of 5…20 seconds according to the parameter set by the TRACETIME command:
Ethernet Port Statistics
Speed 100M Duplex Mode Full
Link State Link Up
Input Output
5 sec Total 5 sec Total
Octets 180 3810 0 0
Ucast Packets 0 0 0 0
NUcast Packets 2 33 0 0
Discards Pckts 1 6 0 0
Errors 0 0 0 0
NTU_PM_S09_P1>
Date 21.10.03
page 15 of 29
