Black Box LR120A, Руководство по началу работы

Страница: 61 / 128

Frame Relay bridged 56
WAN Access Routers Getting Started Guide 6 • WAN Services
Figure 38. Frame Relay Channel configuration
Central site configuration
Note
If you are using a Black Box at the Central location, follow the instructions
below, otherwise refer to your third party router documentation
for configuration.
See the web pages for the Black Box above. Some parametric values will differ, but the process remains
the same.
First configure the IP address of the Ethernet port (interface ip1) via the command line (CLI) for
192.168.172.3/24. The PC (IP address 192.168.172.229) must be on the same subnet for configuring the
Black Box via the web pages.
1. Bring up the web-page management system on your browser by entering the IP address of the Black Box.
2. On the Menu, go to Services Configuration, then to WAN. Delete the factory default WAN services already
defined.
3. Click on Create a new service in the main window, select “Frame Relay bridged” and click on Continue.
4. Enter the description for the circuit in the Description field. This is a mandatory field. Without a descrip-
tion you cannot create a WAN service.
5. Click on Create a new service in the main window, select Frame relay bridged and click on the
Configure
button.
6. Click along the following path: Services Configuration > WAN > ‘Edit...’ Then click on Edit ‘Frame Relay
Channel’. The configurable parameters are:
– DLCI: Consult with your service provider for the DLCI number required.
– Encapsulation type: Bridged Ether (Defines the RFC 1490 encapsulation type to be used by the chan-
nel. In some instances you may need to choose another type. Consult your service provider.)
– RX Max PDU: 8192 Receive side max PDU, default 8192 (normally not changed from default)