Serial Port Profiles
60
Terminal Server User Guide, Version 3.3
Stop Bits
Specifies the number of stop bits that follow a byte.
Data Options:
1,1.5, 2
Default:
1
Duplex
Used with a
EIA-485
serial interface, specify whether the serial port is
Full
Duplex
(communication both ways at the same time) or
Half Duplex
(communication in one direction at a time).
Default:
Full
TX Driver Control
Used with a
EIA-485
serial interface, if your application supports
RTS
(Request To Send), select this option. Otherwise, select
Auto
.
Default:
Auto
Flow Control
Defines whether the data flow is handled by the software (
Soft
), hardware
(
Hard
),
Both
, or
None
.
Data Options:
Soft, Hard, Both, None
Default:
None
Enable Inbound
Flow Control
Determines if input flow control is to be used.
Default:
Enabled
Enable Outbound
Flow Control
Determines if output flow control is to be used.
Default:
Enabled
Monitor DSR
Specifies whether the EIA-232 signal DSR (Data Set Ready) should be
monitored. This is used with modems or any device that sends a DSR signal.
When it is monitored and the Terminal Server detects a DSR signal, the line
profile is started. If both
Monitor DCD
and
Monitor DSR
are enabled, both
signals must be detected before the line profile is started.
Default:
Disabled
Monitor DCD
Specifies whether the EIA-232 signal DCD (Data Carrier Detect) should be
monitored. This is used with modems or any other device that sends a DCD
signal. When it is monitored and the Terminal Server detects a DCD signal, the
line profile is started. If both
Monitor DCD
and
Monitor DSR
are enabled, both
signals must be detected before the line profile is started.
Default:
Disabled
Enable Echo
Suppression
This parameter applies only to
EIA-485
Half Duplex
mode. All characters will
be echoed to the user and transmitted across the serial ports. Some EIA-485
applications require local echo to be enabled in order to monitor the loopback
data to determine that line contention has occurred. If your application cannot
handle loopback data, echo suppression should be enabled.
Default:
Disabled
