17
CHAPTER 3: Installation
Fig. 3-5. Changing the Jumper.
5. Put the top cover of the unit back in place by snapping the two plastic
pieces together. Make sure you line up the back panel, which contains
all the connections into its slots on the bottom and top units.
TP
THIN
TP
THIN
This is the default setting for the
Ethernet Print Server. Move the
jumper from the pins labled
TP
to the pins labled
THIN
. Always
cover the middle row of pins for
either setting.
Once you change the jumper, it
should look like the illustration
above. You can then use your
Thinnet interface for your
network connection.
