106
ETHERNET PRINT SERVERS HIGH SPEED AND 4-PORT
3. Use the tar command to load the program from the diskette.
Choose your example from the following:
• BSD/ULTRIX/AIX—tar -xvf /dev/rfd0
• System V—tar -xvf /dev/rdsk/f13ht
4. After performing the tar, run the nsconfig installation program.
Type the following command:
lpdinst
The Ethernet Print Server lpd configuration utility is now installed.
To use nsconfig, continue.
NOTE
Be sure that all edited parameters in this file reflect your desired
configuration before you save it and run nsconfig.
5. Call up the netprint.conf file and make editing changes. For example,
to make Port 2 handle PCL and PostScript data, your entry should read:
Parallel-port2-data-format PCL PS
NOTE
Parameters in the sample file are default values.
6. Save netprint.conf. Again, first be sure that all edited parameters are
correct, especially your IP address.
7. Run the nsconfig utility with the Ethernet Print Server‘s IP address or
name (from the /etc/hosts file). Type, for example:
nsconfig 192.9.200.200
8. Power the Ethernet Print Server off and on only if you have changed any
of the lpd-specific parameters.
